Posted inMechanics of Marine Machines
Governor characteristics
In normal operation the turbine-generator is synchronised with and connected into an electrical power system,…
Posted inMechanics of Marine Machines
Gravity control
In gravity control – gravity controlled instruments, as shown. A small adjustable weight is attached…
Posted inMechanics of Marine Machines
Comparison between Involute and Cycloidal Gear Tooth Profiles
Involute tooth profile is almost used generally everywhere and given preference over cycloidal tooth profile or any…
Posted inMechanics of Marine Machines
Internal Gears
Internal gear is a gear with its teeth cut in the internal surface of a…
Posted inMechanics of Marine Machines
CONTACT RATIO
To assure continuous smooth tooth action, as one pair of teeth ceases action a succeeding…
Posted inMechanics of Marine Machines
Minimum number of teeth on the pinion in order to avoid interference
Introduction:Interference may only be avoided, if the point of contact between the two teeth is…
Posted inMechanics of Marine Machines
Undercut – Gear Terminology
The undercut of gears is also called deeper cutting and indicates the phenomenon of cutting…
Posted inMechanics of Marine Machines
Terminology for Spur Gears
Figure 7-4 shows some of the terms for gears. Figure 7-4 Spur Gear In the following…
Posted inMechanics of Marine Machines
Involute Curve
The following examples are involute spur gears. We use the word involute because the contour of gear…